Control Module
/Overview/
ACI’s A8KSUB-2AC is a sub-assembly attached to the back plane of the A8KMF3 chassis and provides the plug-in locations for up to two(2) A8KAPS power supplies and one(1) A8KPCM control module.
/Features/
A8KSUB-Sub-assembly Backplane
Plug-in location for two(2) A8KAPS power supplies and one(1) A8KPCM control module
With 10/100 ethernet LAN port
With two AC power cord strain relief clip
IEC 320 inlet plug
1002 MHz CATV or LAN Amplifier
/Overview/
ACI’s A8K-FDA amplifier module has been designed for use in both CATV headend and broadband local area network (LAN) applications. The FDA module is based on ACI’s A8K Transmission platform may be used in any network with a bandwidth requirement of 45 to1002 MHz. In two-cable networks, it is designed to operate in a one-way mode. Both gain and slope can be adjusted electronically through PCM controller on the A8K platform. The gain control is available for gain adjustment from 0 to 20 dB per 1 dB steps. The slope can be adjusted
from 0 to 10 dB. RF input level can be adjusted by plug-in pad on the rear panel. Directional coupler test points are available on the front panel to monitor the input and on the rear panel to monitor the output RF levels. On the rear panel are RF input and output ports with F- type connectors.
/Features/
Bandwidth 45 to 1002 MHz
30 dB gain at 1002 MHz
0 ~ 20 dB gain control (controlled by microprocessor)
0 ~ 10 dB slope adjustment (controlled by microprocessor)
-20 dB DC input test point
-20 dB DC output test point
19” Rack mount and 1 RU in height
120 VAC 60 Hz or 220 VAC 50/60 Hz power supply
Optional -48 VDC power supply is also available
Optional Dual power supply for backup
/Panel/
1550nm (C-Band) EDFA Module
/Overview/
ACI’s A8KEAM 1550nm (C-Band) EDFA (Erbium-Doped Fiber Amplifier) module single-channel optical amplifier is designed for long-haul or wide broadcast optical fiber system, with compact, high reliability, scalability and cost-effectiveness. The module is hot-swappable with integrated management through A8KPCM and remote management by HMS SNMP. Maximum 16 modules
can reside in the 19-inch high-density A8KMF3 chassis. The output monitor port is available for the real-time monitoring without interrupting the service.
/Features/
High output power
Low noise figure
Operating windows: 1540~1560 nm
Optical Input power from –5 ~ 8 dBm
Optical output power from 17 ~ 23 dBm
Low power consumption
Remote control and status monitor
Designed for hot-swappable
SMF-28 Type Input/Output Optical Fiber
Booster amplifier for long haul broadcast
Single channel application
Advanced alarm function
SC/APC Input/Output Optical Connector
/Applications/
